The increasing risks resulted by blast loads in current broad and thin plates necessitate the studies and evaluation of these challenges. Practical and cost-effective solutions such as plates enforcement with stiffener are suggested due to high displacement of structure as a result of applied loads. Moreover, application issues and the possibility of developing opening in plates and thus their change of behavior are considered important issues, for which solutions are suggested in this study. Functionally graded plates (FGM) with a power distribution in the direction of thickness are suggested as a solution to this challenge. Accordingly, the present study assesses parameters related to plates with opening including kind, percentage and the position of opening, the mass amount of explosive material, and the parameters related to plates with stiffener including type, count, arrangement of stiffeners, boundary condition and also the joint effect of stiffener and opening using Abaqus Software. The results indicate that opening decreases the plate hardness which consequently increases the amount of displacement. Plate displacement constantly reduces as a result of increase in opening percentage and hence decrease in the surface on which load is applied. On the other hand, the rectangle shape of stiffener has a better performance due to higher moment of inertia and easier application compared to other shapes. By studying the joint effects of these factors, it can be suggested that developing opening and application of an appropriate stiffener can significantly reduce the amount of plate displacement compared to other types.